World Sleep Industry ENCYCLOPEDIA

Bedroom Circadian Light Strips

1.3.1

Definition and form

A bedroom circadian light strip is linear lighting installed along a bed, wall recess, ceiling detail or furniture. It changes brightness, white-light appearance or colour over time to shape an indirect daily light environment. The strip, driver, controller, sensors and mounting channel form one system. A strip labelled “circadian” does not automatically provide a sensible schedule or a verified exposure at the user's eye.

Indirect distribution and placement

Strips can illuminate a wall or ceiling so that reflected light creates an even background. Visible LED points in the pillow sight line can cause glare and specular dots, while an excessively deep recess can waste light and form bands. Low-level under-bed lighting is useful for nighttime orientation but is not daytime general lighting. Make a sample using the actual finishes, reflectance and viewing positions before relying on a promotional rendering.

Spectrum, output and schedule

Tunable-white systems mix warm and cool channels; colour systems use additional channels. Correlated colour temperature does not fully describe spectrum or circadian stimulation, and a colour setting does not replace eye-level illuminance assessment. A schedule may provide brighter neutral light by day, dim progressively in the evening, and switch off or retain only necessary path light during sleep. It must be coordinated with windows, other luminaires and the user's routine.

Power, voltage drop and heat

Conductor resistance over a long run can cause voltage drop, visible as dimming or colour change toward the far end. Power injection and segment lengths must suit load and conductor size. The driver needs suitable capacity in a ventilated, serviceable location. Bonding a strip to a thermally insulating surface can accelerate depreciation; an aluminium channel helps only with proper contact and airflow. Qualified installation should address wiring, joints and overcurrent protection. Drivers, controllers and branch connectors should not be permanently sealed inside a ceiling or furniture cavity that cannot be inspected.

Control and failure behaviour

Control may use a wall panel, wireless gateway or schedule. Channels should remain coordinated at low output rather than dropping out one at a time. Test behaviour after network loss, a false sensor trigger and power restoration. Retain an obvious local switch and a way to obtain safe task lighting, while preventing an automation from repeatedly illuminating the sleeping room. Controller and gateway indicators should be dimmable or hidden.

Commissioning and evaluation

Commission daytime, pre-sleep and night scenes separately. Check eye-level glare, surface uniformity, the stable minimum, temporal modulation, electrical noise and spill onto a bed partner. Illuminance records need position, direction and scene. A phone camera may reveal bands but is not a calibrated flicker assessment. Transitions should be smooth, and later cleaning or furniture movement must not obstruct ventilation or service access.

Care and limits

Inspect for failed adhesive, loose channels, warm connectors, local discoloration and driver noise. Disconnect power before cleaning and keep liquid out of exposed connections. Replace failed sections according to system voltage and colour specification. A circadian strip is part of architectural lighting; “full spectrum” or automatic colour change does not establish treatment of insomnia, and it cannot replace adequate daytime light and control of unwanted nighttime light.